Push Pin Use

We use a push pin system for extending The Smart Handle Pro™ handles.  This system allows the user to adjust the handle quickly and easily!

Our lower shaft is 7/8" OD aluminum, and it fits nicely into our 1" OD upper handle.  These diameters keep the handle snug, yet allow quick and easy adjustment.

We also use "double headed push pins" for extra stability.  And, being made of titanium, these push pins are built to last!

Adjusting the length of the handles: Step 1: Push in the pins Step 2: Pull/Push the lower portion inside the upper handle... Step 3: to desired pre-set position.

To print the instructions on their own page: Right click the upper left corner of the box below.  Drag your mouse over the entire box.  Click "File", select "Print" and click the "Selection" box in your print screen.  This will print the operating instructions in full, on their own page.

Push Pin Adjustment Directions for The Smart Handle™ Push Broom and The Smart Handle Pro™ Utility Handles. Follow these steps if your component does not line up properly: Step 1: Push in the pins and pull out the lower portion. Step 2: Push in the pins with one hand... Step 3: and pinch the top of the push pin with the other hand. Step 4: Pull the push pin completely free from the lower portion. Step 5: Turn the pins sideways... Step 6: and reinsert into the second set of holes. Reinsert your lower portion and your component should now line up properly!

191 South Gulph Road, King of Prussia, PA 19406 Toll Free: 800-435-7338      Toll Free Fax: 800-752-2531